Synthesis and Characterization of Silica from Lapindo Mud Waste with Acid and Base Solvents

Yurdien Dellan Riesnawa; Atha Nur Azaria; Reva Edra Nugraha

Authors

Yurdien Dellan Riesnawa Universitas Pembangunan Nasional "Veteran" Jawa Timur Author
Atha Nur Azaria Universitas Pembangunan Nasional "Veteran" Jawa Timur Author
Reva Edra Nugraha Universitas Pembangunan Nasional "Veteran" Jawa Timur Author

Keywords:

Lapindo mud, silica, precipitation, leaching

Abstract

Lapindo mud is a geological waste product resulting from the mud eruption in Sidoarjo, East Java, Indonesia, which continues to raise environmental concerns. However, this material has considerable potential due to its high silica (SiO₂) content. This study evaluates the effectiveness of acid leaching and alkaline precipitation methods for extracting silica from Lapindo mud and investigates the properties of the resulting silica. Acid leaching was conducted using HCl (4, 8, and 10 M), while alkaline treatment employed NaOH (2, 6, 8, 10, and 12 M) and KOH (8, 10, and 12 M). The results showed that acid leaching is effective in removing metallic impurities without dissolving the silica framework, resulting in only a limited increase in SiO₂ content from 54% to 57%. On other hand, silica purity was greatly increased by precipitation using a base solvent; the maximum SiO₂ content was achieved at 97.5% with 10M NaOH. Nitrogen adsorption-desorption analysis shows that the precipitated silica had mesoporous properties with a type IV isotherm and an average pore size of 20.60 nm, while XRD analysis verifies the conversion of crystalline silica into amorphous silica. Thus, the most efficient technique for generating high-quality silica from Lapindo mud waste is alkaline precipitation with 10M NaOH

References

[1] A. Baydhowi and Soebagio, “Perencanaan Sistem Drainase Dikawasan Tanggul Lumpur Sidoarjo,” Jurnal Rekayasa dan Manajemen Konstruksi, vol. 9, no. 1, pp. 17–022, 2021.

[2] A. Rahmayanti, Q. A’Yuni, H. Hartati, P. Purkan, and I. G. Romanza, “Synthesis and characterization of silica gel from Lapindo mud Sidoarjo,” in IOP Conference Series: Earth and Environmental Science, Institute of Physics Publishing, Apr. 2020. doi: 10.1088/1755-1315/456/1/012007.

[3] Q. A’yuni et al., “Synthesis and characterization of silica gel from Lapindo volcanic mud with ethanol as a cosolvent for desiccant applications,” RSC Adv., vol. 13, no. 4, pp. 2692–2699, Jan. 2023, doi: 10.1039/d2ra07891k.

[4] N. Andarini, T. Haryati, S. Suwardiyanto, and Y. A. Sulistiyo, “Synthesis of Zeolite Y from Lapindo Mud with the Comparative Variation of the Weight of NaOH/Mud and Molar SiO2/Al2O3,” Indonesian Chimica Letters, vol. 1, no. 1, pp. 8–12, Jun. 2022, doi: 10.19184/icl.v1i1.5.

[5] I. Abdellaoui, M. M. Islam, T. Sakurai, S. Hamzaoui, and K. Akimoto, “Impurities removal process for high-purity silica production from diatomite,” Hydrometallurgy, vol. 179, pp. 207–214, Aug. 2018, doi: 10.1016/j.hydromet.2018.06.009.

[6] Y. Chambioso, A. L. Juwono, and A. Daulay, “Synthesis and Characterization of Amorphous Silica Nanoparticles Production from Indonesia Coal Fly Ash,” Journal of Chemical Natural Resources, vol. 7, no. 2, pp. 96–104, Dec. 2025, doi: 10.32734/jcnar.v7i2.23383.

[7] M. Amin et al., “Processing of Granite Quarry Solid Waste into Industrial High Silica Materials using Leaching Process with HCl Concentration Variation,” Jurnal Riset Teknologi Pencegahan Pencemaran Industri, vol. 11, no. 2, pp. 43–50, Oct. 2020, doi: 10.21771/jrtppi.2020.v11.no.2.p43-50.

[8] S. A. Ajeel, K. A. Sukkar, and N. K. Zedin, “Extraction of high purity amorphous silica from rice husk by chemical process,” in IOP Conference Series: Materials Science and Engineering, Institute of Physics Publishing, Aug. 2020. doi: 10.1088/1757-899X/881/1/012096.

[9] E. Febriana et al., “Dissolution of quartz sand in sodium hydroxide solution for producing amorphous precipitated silica,” in IOP Conference Series: Materials Science and Engineering, Institute of Physics Publishing, Jul. 2020. doi: 10.1088/1757-899X/858/1/012047.

[10] B. Dousova, L. Fuitova, D. Kolousek, M. Lhotka, T. M. Grygar, and P. Spurna, “Stability of Iron in Clays Under Different Leaching Conditions,” Clays Clay Miner., vol. 62, no. 2, pp. 145–152, Apr. 2014, doi: 10.1346/CCMN.2014.0620207.

[11] A. Ubaid, N. Hidayat, and Munasir, “Aging Time Effect on Porous Characteristics of Natural Mud-based Silica Prepared by Hydrothermal-Coprecipitation Route,” in IOP Conference Series: Materials Science and Engineering, Institute of Physics Publishing, May 2017. doi: 10.1088/1757-899X/202/1/012022.

[12] I. Ramadhani, B. Oktavia, A. Putra, and H. Sanjaya, “Penentuan Kondisi Optimum Pembentukan Natrium Silikat (Na 2 SiO 3 ) Menggunakan Material Dasar Silika Alam dan Natrium Hidroksida (NaOH),” Chemistry Journal of Universitas Negeri Padang, vol. 10, no. 2, pp. 22–7, 2021, [Online]. Available: http://ejournal.unp.ac.id/index.php/kimia

[13] M. M. Arisqi, R. Junaidi, and Fadarina, “Tinjauan Sistem Pengering Silika Gel Berbasis Abu Sekam Padi Menggunakan Sistem Vakum Tray Dryer Terhadap Kemampuan Daya Serap Overviem Of Silica Gel Drying System Based On Rice Husk Ash Using A Tray Dryer System On This Absorption Ability,” Jurnal Kinetika, vol. 12, no. 03, pp. 26–30, 2021, [Online]. Available: https://jurnal.polsri.ac.id/index.php/kimia/index

[14] T. Hu, W. Gao, X. Liu, Y. Zhang, and C. Meng, “Synthesis of zeolites Na-A and Na-X from tablet compressed and calcinated coal fly ash,” R. Soc. Open Sci., vol. 4, no. 10, Oct. 2017, doi: 10.1098/rsos.170921.

[15] E. Mohiuddin, Y. M. Isa, M. M. Mdleleni, and D. Key, “Effect of kaolin chemical reactivity on the formation of ZSM-5 and its physicochemical properties,” Microporous and Mesoporous Materials, vol. 237, pp. 1–11, Jan. 2017, doi: 10.1016/j.micromeso.2016.08.028.

[16] S. Sembiring, Potensi Silika Sekam Sebagai Bahan Keramik Refraktori Tahan Pada Suhu Tinggi, 1st ed. Yogyakarta: Teknosain, 2017.

[17] M. Thommes et al., “Physisorption of gases, with special reference to the evaluation of surface area and pore size distribution (IUPAC Technical Report),” Pure and Applied Chemistry, vol. 87, no. 9–10, pp. 1051–1069, Oct. 2015, doi: 10.1515/pac-2014-1117.

[18] Fatimah, M. Turmuzi, Z. Latifah Syam, and T. Putri Yunita, “Pengaruh Konsentrasi Pelarut NaOH dan Waktu Aging pada Pembuatan Silika Gel dari Fly Ash Batu Bara,” Jurnal Teknik Kimia USU, vol. 12, no. 2, pp. 124–131, Sep. 2023, doi: 10.32734/jtk.v12i2.13314.

[19] Nurmustaqimah, S. Jamilatun, and A. Rahayu, “Effect Of NaOH Concentration On Surface Width And Pore Volume Of Silica Gel From Beef Shrain As Adsorbent,” Jurnal Sains Natural, vol. 15, no. 2025, pp. 102–109, Feb. 2025.