Analisa Perbandingan Metode Lifting Hammer Menggunakan Crane dan Frame Portal untuk Uji PDA Pada Tiang Bore Pile Berdasarkan Analisa Mutu, Waktu dan Biaya
Keywords:
Keywords: pda, borepile, efficiency, cost, portal frameAbstract
The foundation is an important part of building construction, acting as a support for the building and transferring loads evenly from the upper structure to the ground. In construction projects, one of the most important activities is to test the bearing capacity of bore piles using the Pile Driving Analyser (PDA) method. The purpose of this test is to ensure that the capacity of the bored pile can meet the structural requirements of the toll road, particularly in the face of significant vertical and lateral loads. Improving the efficiency of the PDA (Pile Driving Analyzer) testing method is an important challenge in the foundation of bored piles in infrastructure projects. This study discusses the analysis of the use of the Frame Portal PDA as an alternative to the crane hammer method. The analysis includes quality, time and cost aspects on the Toll project. The results show that the PDA Portal Frame method is more efficient with a cost saving of Rp109,010,524.00 and a reduction in implementation time for 2 days of test points compared to the crane method. In addition, the PDA Portal Frame structure has a maximum deformation of 0.030 mm, which is within safe limits according to SNI 2847-2019.
References
1. ASTM D-4945-2017, "Standard Test Method for High-Strain Dynamic Testing of Deep Foundations."
2. SNI 2847-2019, "Persyaratan Beton Struktural untuk Bangunan Gedung."
3. SNI 1727-2013, "Beban Minimum untuk Perencanaan Bangunan Gedung dan Struktur Lain."
4. Setiawan, A. (2013). Perencanaan Struktur Baja dengan Metode LRFD. Jakarta: Buku Gabusan.
5. SNI 1729:2015 "Spesifikasi untuk Bangunan Baja Struktural". Badan Standarisasi Nasional (BSN), Jakarta, 2015.
6. Struyk, J., & Veen, M. (1984) "Bridge Engineering Principles". Springer-Verlag, New York.
7. Andryan Suhendra, dan. (2018). Studi Kapasitas Tiang Bor Berdasarkan Metode Pile Driving Analyzer (PDA) dan Load Cell. In Jurnal Mitra Teknik Sipil (Vol. 1, Issue 1).
8. Rasdinanta Tarigan. (2020). Komparasi Kinerja Alat Pile Driving Analyzer Dan Software Capwap Dalam Menghasilkan Daya Dukung Ultimit Pondasi Tiang. In Jurnal Darma Agung (Vol. 28, Issue 3).
9. Spesifikasi untuk bangunan gedung baja struktural Badan Standardisasi Nasional. (2015). www.bsn.go.id
10. Hardiyatmo, H. C. (2017). Analisis dan Desain Pondasi (Edisi ke-3). Yogyakarta: Gadjah Mada University Press.
11. Das, B. M. (2015). Principles of Foundation Engineering (8th ed.). Cengage Learning.
12. Fellenius, B. H. (2001). "From Strain Measurements to Load in an Instrumented Pile." In Geotechnical News Magazine (Vol. 19, Issue 1).
13. Salgado, R. (2008). "The Engineering of Foundations." McGraw-Hill.
14. Bowles, J. E. (1996). Foundation Analysis and Design. McGraw-Hill.
15. Randolph, M. F., & Dolwin, J. B. (2001). "Application of the Pile Driving Analyzer for Offshore Piles." Marine Geotechnology, 20(1), 23-45.
Downloads
Published
Issue
Section
License
Copyright (c) 2024 Ali Zainal Abidin Isa Alhabsyi, Ifthar Ramadhana W, Hendrata Wibisana, Karina Meilawati Eka Putri (Author)
This work is licensed under a Creative Commons Attribution 4.0 International License.
